KELVIN HUGHES HBK-4002 Quick Start Manual page 19

Dual Radar dispay tabs
The ESS tab in dual radar
display is currently
Under Development
Kelvin Hughes
MANTADIGITAL
Go to Run ...
5
Chapter :
(continued)
Docking tab
When connected to a compatible sensor, the Docking tab
displays information on heading, speed, wind and depth.
Note: Where connected, wind can be changed from true to relative.
Route tab
A primary route can be loaded or deselected.
Route settings can also be accessed allowing the level of
detail for a route to be set and critical points (CP) to be
added to the loaded route.
CCTV tab (picture-in-picture)
Where enabled, the CCTV tab displays video from a
compatible external video source such as a CCTV system.
This is not a standard feature but is available as an optional
feature.
NOTE: There are no operator adjustable parameters or camera controls
in the CCTV tab.
ETD mode tab
This tab shows Enhanced Target Detection (ETD) mode.
ETD is not a standard feature but is available as an optional
feature.
section in part 1 of the Operator's handbook
See the ETD
for further details.
Camera tab
This is the display and control of the optional FLIR night
vision camera. The direction of the camera can be adjusted
using the on-screen buttons.
The camera can also be locked to a radar tracked target,
VRM/EBL or ground position.
This is not standard but is available as an optional feature.
ESS (Enhanced Spyscope)
ESS mode is under development and is currently not
available for use.
HBK-4002, issue 2 February 2013
Page 19 of 26
TM
Quick Start Guide: