Ecdis Mode - KELVIN HUGHES HBK-4002 Quick Start Manual

5.5 ECDIS mode

Transceiver activation from standby screen
When ECDIS mode is started
from the standby screen, the
transceiver selected as Master
will transmit and the antenna
will rotate.
Transceiver activation when changing display modes
A navigation mode controlling
(mastering) a transceiver.
i.e. it is transmitting and the
antenna is rotating.
Stop the transceiver/ antenna
Setting the system to Standby stops a mastered transceiver but does not switch it OFF.
Kelvin Hughes
MANTADIGITAL
Go to Run ...
5
Chapter :
If the optional
radar interlay is
enabled, firstly
select the desired
transceiver.
From the standby
screen select
ECDIS.
Select the Radar control icon
then Radar OFF
Change navigation mode to
ECDIS using Selected Display
Mode.
i.e. not returning to Standby
screen.
HBK-4002, issue 2 February 2013
Page 22 of 26
TM
Quick Start Guide:
The transceiver continues to
transmit and the antenna will
rotate but radar interlay is not
ECDIS selected; the
transceiver continues to
transmit and antenna rotates.
shown.