Getting Started; Switching On - KELVIN HUGHES HBK-4002 Quick Start Manual

TM
Kelvin Hughes Quick Start Guide:
MANTADIGITAL
4

Getting started

Chapter :
4 Getting started

4.1 Switching ON

Ensure that the external AC mains supplies to the display, processor and all associated
equipment are switched ON at source.
Processor ON:
TM
Ensure the navigation processor power switch is in the ON position.
MANTADIGITAL
MantaDigital processor power switch:
0 = OFF
I = ON
Note: If the processor switch is in the OFF position, the system cannot be started from the display.
Display ON:
To switch the system ON, press the ON/ OFF button on the display control panel:
MantaDigital display control buttons
Startup screen:
The system will now start and the two fans mounted in the MantaDigital navigation processor
will run. During the boot-up/ start-up sequence, the following will appear on-screen:
After a short delay, the system
will automatically start with the
Kelvin Hughes standby screen.
Start-up screen MANTADigital standby screen
HBK-4002, issue 2 February 2013
Page 5 of 26