Go To Run; Single Radar Display - KELVIN HUGHES HBK-4002 Quick Start Manual

5 Go to Run ...

Depending on the system
configuration, the following modes can
be selected from the standby screen:
 Single radar display.
 Dual radar display.
 Conning display.
 Navigation & conning display.
 ECDIS mode.
The following section shows how to run
each mode from the standby screen.
WARNING – Antenna rotation:
Selecting Radar, ECDIS or navigation & conning display modes will cause the selected
(mastered) transmitters to transmit and antennas to rotate.

5.1 Single radar display

Transceiver activation from standby screen
When single radar display mode is started, the transceiver selected as Master in the standby
screen is set to Run causing it to transmit and the antenna to rotate.
Setting the system back into Standby stops a mastered transceiver but does not switch it
OFF.
Kelvin Hughes
MANTADIGITAL
Go to Run ...
5
Chapter :
On interswitched
systems, firstly
select the desired
transceiver.
From the standby
screen select
Single Radar
Display.
HBK-4002, issue 2 February 2013
Page 17 of 26
TM
Quick Start Guide: