Conning Display - KELVIN HUGHES HBK-4002 Quick Start Manual

5.3 Conning display

When conning display mode is started, no transceivers are set to run mode. However it
should be noted that all transceivers are still in Standby unless they are being used by
another display.
Transceiver activation when changing display modes
A navigation mode controlling
(mastering) a transceiver.
i.e. it is transmitting and the
antenna is rotating.
When changing to ECDIS or
navigation & conning display
modes from Conning mode, the
transceiver will remain in
standby
Stop the transceiver/ antenna
Setting the system to Standby from any navigation mode stops a mastered transceiver but
does not switch it OFF.
Kelvin Hughes
MANTADIGITAL
Go to Run ...
5
Chapter :
From the standby
screen select
Conning Display
Change navigation mode to
Coning display using Selected
Display Mode.
i.e. change mode without
returning to Standby screen.
Change navigation mode to
Navigation & conning display
using Selected Display Mode.
i.e. change mode without
returning to Standby screen.
HBK-4002, issue 2 February 2013
Page 20 of 26
TM
Quick Start Guide:
Conning display has no radar
function so the transceiver is
placed into Standby; i.e. it does
not transmit and the antenna
does not rotate.
When the navigation and
conning display starts, the
transceiver will transmit and the
antenna will rotate.