Table of Contents
Advertisement
4.7.6 Closing tabs and menus
4.7.7 Tick boxes
Some features require a tick-box to be selected. To select a tick box, place the cursor in the
box and left click.
Tick box function ENABLED
4.8 MANTADIGITAL Control Interface (MCI) panel
The optional MantaDigital Control Interface (MCI) panel allows the operator quick access to
common functions including gain, auto-sea and rain clutter, range, EBL and VRM.
Each function is detailed in the relevant section of the operator's handbook, i.e. for use of the
Gain control on the MCI panel, see Gain control in the operator's handbook HBK-4001 pt 1:
A to Z operators instructions.
NOTE: The F1 and F2 buttons are currently not assigned and have no function
MCI panel backlight brilliance
Repeated presses of the BRILL button on the MCI panel vary the backlight
for the panel from OFF (1st press) to maximum in 6 steps.
On the 7
Kelvin Hughes
MANTADIGITAL
4
Getting started
Chapter
:
Some dialogs and menus must be closed by clicking on
located at the top-right of some tabs/ menus.
Caution: Some functions may not be accessible until a
menu or tab is closed.
th
press the control reverts to OFF and the cycle starts again.
HBK-4002, issue 2 February 2013
Page 15 of 26
TM
Quick Start Guide:
Tick box function DISABLED
X
which is
Advertisement
Table of Contents
