MG GS Owner's Handbook Manual page 258

this time, the cruise control system will maintain the set
speed without pressing the accelerator pedal.
Note: The set speed held in the cruise control memory
will be canceled when either the cruise control lever is
switched to "ASL In Standby" position (figure 7) or the
ignition switch turned off.
Target Cruise Speed Adjustment
When the cruise control is active, the 'target speed' can be
increased or decreased:
Push the lever switch upwards (1 in figure), this will
increase the speed.
Push the lever switch downwards (2 in figure), this will
decrease the speed.
Release the lever switch when the desired speed is reached.
Push the lever switch upwards or downwards briefly to
increase/decrease the vehicle target speed in increments
of 1mph/1km/h, then the vehicle will accelerate/decelerate
to the new target speed.
STARTING & DRIVING
Pressing the accelerator at any time will override the cruise
control and allow acceleration to undertake manoeuvres
such as overtaking. Releasing the accelerator will return
the vehicle to the set target speed.
Pause/Stand By
Cruise control will be disengaged and set to 'Standby' if:
• Lever switch moved to 'Cruise Cancel' position (3 in
figure).
• Brake pedal pressed.
• Auto gear lever moved to P, R or N.
• Manual gear-change made.
• Clutch pedal pressed.
• Conditions initiate SCS intervention.
• An incline causes excessive decline in speed.
• The EPB button is operated.
Resume
If the cruise control remains on after the disengagement,
moving the lever switch to 'Cruise Resume' (5 in figure)
will reinstate the target speed to the setting prior to
disengagement.
4
241