Scale; Signal - Barco G62 User Manual

User controls — Installation
• Letter boxing
• Native
Select Auto to display the detected image size.

7.4 Scale

About scale
Digitally scale the image size and position to fit onto the actual projection surface.
Digital Zoom
Digitally adjust the size of the projected image.
• Horizontal: Change the width of the projected image.
• Vertical: Change the height of the projected image.
Digital Shift
Adjust the position of the display area within the lens offset range. You need to digitally zoom the image before
using the Digital Shift function.
• Horizontal: Horizontally shift the image.
• Vertical: Vertically shift the image.
Reset
Reset the function settings to factory default values.

7.5 Signal

About signal
Configure the settings to correctly project the input signals and transfer the output signals.
Auto Signal
When Auto Signal is enabled, the projector automatically detects and selects the input signal. Once an input
source is selected, press the Input button on the remote control or keypad to switch to other available sources.
Backup Input
Backup Input function allows the user to set up two input sources with the same timing specification. Upon
loss of one input source, the projector automatically switches to the other source.
This function can be useful for the installations requiring uninterruptedly displaying the content source, such
as live show, exhibition, and critical control room.
• Auto Switch: Check the box to enable automatically switch to backup input source when the current
source fails.
• Current Signal: Displays the current active signal.
• First Input: Select a signal as the first input source. Once the selected source is activated, the OSD menu
lists out the signal's Resolution, Horz Refresh (horizontal refresh rate), and Color Space.
• Second Input: Select a signal as the second input source. Once the selected source is activated, the OSD
menu lists out the signal's Resolution, Horz Refresh (horizontal refresh rate), and Color Space
• Backup Input Status: Display the function status. The Backup Input Status is active when meeting the
following conditions:
- Auto Switch is checked.
- The two sources are with the same timing specification.
- The two sources are active.
- Projector is displaying one of the two sources.
44 R5914653 /02 G62