Important Safety Instructions - Barco G62 User Manual

This projector is class 1 laser product of IEC/EN 60825-1:2014 and risk group 2 with the requirements of IEC
62471-5:2015.
Operators shall control access to the beam within the hazard distance or install the product at the height that
will prevent exposures of spectators' eyes within the hazard distance (When Throw Ratio large than 2.9).
Additional instructions to supervise children, no staring, and not use optical aids.
Notice is given to supervise children and to never allow them to stare into the projector beam at any distance
from the projector.
Notice is given to use caution when using the remote control for starting the projector while in front of the
projection lens.
Notice is given to the user to avoid the use of optical aids such as binoculars or telescopes inside the beam.
Light Intensity Hazard Distance
This projector may become Class 1 Laser Product-Risk Group 3 (RG3) when installed with G LENS (2.90 -
5.50 : 1) lens (throw ratio 2.90-5.50). Permanent eye injury is possible when exposed to the high intensity light
beam within the hazard distance (HD).
Projection
Throw Ratio
Lens
G LENS (2.90 - 2.90-5.50
5.50 : 1)
Follow the precautions to avoid light intensity hazard.
• NEVER look into the lens! High intensity light beam.
• Permanent eye injury is possible when exposed to the high intensity light beam within the hazard distance.
• Operators shall control access to the light beam within the hazard distance or install the product at a height
that will prevent eye exposure within the hazard distance.
• Do not place any reflective objects in the light path of the projector.
User definition
Throughout this manual, the term SERVICE PERSONNEL refers to Barco authorized persons having
appropriate technical training and experience necessary to be knowledgeable of potential hazards to which
they are exposed (including, but not limited to HIGH VOLTAGE ELECTRIC and ELECTRONIC CIRCUITRY
and HIGH BRIGHTNESS PROJECTORS) in performing a task, and of measures to minimize the potential risk
to themselves or other persons. Only Barco authorized SERVICE PERSONNEL, knowledgeable of such risks,
are allowed to perform service functions inside the product enclosure. The term USER and OPERATOR refers
to any person other than SERVICE PERSONNEL. When installing an interchangeable lens with a throw ratio
that make the projector become RG3, refer to chapter "Risk Group 3 Safety", page 9. Such combination of
projector and lens are intended for professional use only, and are not intended for consumer use.
FOR PROFESSIONAL USE ONLY means installation can only be carried out by Barco AUTHORIZED
PERSONNEL familiar with potential hazards associated with high intensity light beams.

1.2 Important safety instructions

To prevent the risk of electrical shock
• This product should be operated from a mono phase AC power source.
• This apparatus must be grounded (earthed) via the supplied 3 conductor AC power cable. If none of the
supplied power cables are the correct one, consult your dealer. If you are unable to insert the plug into the
outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-
type plug.
• Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the
cord. To disconnect the cord, pull it out by the plug. Never pull the cord itself.
Classification and Requirements for Laser Illuminated Projectors
IEC 60825-1:2014
CLASS 1
(LIPs)
IEC 62471-5:2015
RISK GROUP 3 Hazard distance: 2.30
R5914653 /02
Safety
m
G62 11