Advanced Image - Barco G62 User Manual

8.10 Advanced Image

About advanced image
Configure advanced image settings to correctly project specific image formats for more complicated
applications.
Dynamic Contrast
Set up the Dynamic Contrast to maximizing the contrast for dark content.
• Dynamic Black: Enable the function to automatically adjust the contrast ratio for video sources. It
improves the black level in dark scenes by reducing the light output.
- Speed: Adjust the speed of the light source correction. The value ranges from 1 to 15. A lower value
makes the correction slower and less aggressive while a higher value results in the faster correction.
- Strength: Set the strength of the dynamic contrast adjustment. The value ranges from 0 to 3, the
higher the value the stronger the correction.
- Level: Adjust the light source when the brightness level of the current content gets lower than the set
value. The value ranges from 50% to 100%. The higher the value, the larger the range to adjust the
light source.
• Extreme Black: Enable the function to automatically automatically increase the contrast ratio by turning off
the laser light when black image is detected.
- Light Out Timer: Set a timer for the laser light to turn off after detecting black content. The set value
ranges from 0s to 20s.
- Light Out Signal Level: Set a black level value as the threshold for the Real Black function. The value
can be selected from 0 to 5, with 0 being the darkest black and 5 being the brightest.
• Reset: Reset the function settings to factory default values.
3D Setup
3D video file combines two slightly different images (frames) of the same scene representing the different
views that the left and right eyes see. When these frames are displayed fast enough and viewed with 3D
glasses synchronized with the left and right frames, the viewer's brain then assemble the separate images into
a single 3D image. 3D Menu provides options to set up the 3D functions to correctly display 3D videos.
• 3D Mode: Enable or disable the 3D function.
• 3D Format: Select a proper 3D format for the 3D input signal. The available options are Auto, Frame
Packing, Side by Side, Top and Bottom, and Frame Sequential.
• 3D Tech: Select a proper 3D technology according to how the 3D sync signal is processed.
- DLP-Link: Select DLP-Link when the 3D sync signal is generated by the DLP Link technology built-in
the projector. DLP Link works only with the glasses that are compatible with DLP 3D technology and
the 3D function is enabled
- 3D Sync: Select 3D Sync when the 3D sync out signal is sent to an emitter or another projector through
the 3D sync out port.
• 3D-2D: Transform the 3D content to 2D images.
- 3D: Play the 3D content normally.
- 2D-Left: Play the left images of the 3D content.
- 2D-Right: Play the right images of the 3D content.
• 3D Sync Out: Set up the transmission of the 3D sync output signal.
- To Emitter: Send the 3D sync signal to the emitter connected to the 3D sync out port.
- To Next Projector: Send the 3D sync signal to next projector when using multiple projectors.
• 3D Invert: When the 3D video does not appear correctly, use this function to invert the 3D left and right
frames.
• Frame Delay: Set a frame delay value for the projector to correct the time difference between the 3D
signal being given and the result being executed. This function works only when L/R Reference is set to
Field GPIO. When performing 3D blending on multiple projectors, set the frame delay for each projector to
correct the non-synchronous images.
• Reset: Reset the function settings to factory default values.
User control — Image menu
R5914653 /02 G62 55