Advertisement
INSTALLATION
Installation of mopping cloth | 2 in 1 electric-controlled water tank
1
Paste the mopping cloth flat onto the bottom
of the water tank.
4
Remove the mopping module
When the robot is finished working, press
the button in the middle of the water tank
Robot
to remove the mopping module backwards,
empty the water in the water tank and clean
the mopping cloth (do not move or turn the
robot over during cleaning).
2
Fill the water tank: uncap the cover and fill
with water.
Instructions for mopping module
1. Please do not use the mopping module after it has been left unused.
2. For safety reasons, please be sure to remove the mopping module when it is being charged
or left unused.
3. Please do not mop the carpet. Set a forbidden area in the Bluebot app to prevent the
machine from going onto the carpet.
4. To achieve a better mopping effect, the mopping module should be installed after
sweeping the floor first.
5. To add water or clean the dust cloth when the machine is working, please pause it, and
take out and reassemble the mopping module according to step 3. Please do not move or
turn the robot over, otherwise, it could fail in its positioning, lose its map and "forget" the
forbidden areas that are programmed.
6. The mopping function of the machine is intended for wiping and is not conducive to deep
cleaning. It cannot remove stubborn stains effectively and replace the labour force.
3
Press and hold the button in the middle of the
tank and push it horizontally along the rear
of the robot. The module is installed in place
correctly if you hear the sound of a "click".
Mopping module
Advertisement
