Advertisement
PRODUCT INTRODUCTION
Adapter
1. Connect the adapter and wrap the excess
wire around the wrapping post in the
storage groove
Charging base
Adapter
• Ensure a space of above 1 m on both sides of the charging base and a space of above 1.5m in the front
• If the power line is vertical to the ground, it may be dragged by the robot and consequently, the charging base may be powered off
• The charging indicator is normally on when powered on and off when charged
• If the charging base is relocated, the robot may fail in its positioning and lose the map. When restarted, the robot will rebuild and
memorise the map and the rebuilt map may lose the cleaning information for forbidden areas and other areas
• Direct sunlight will interfere with recharging signal and consequently, the robot may be unable to return to the charging base
2 in 1 electrically-
Remote control
controlled water tank
2. Place the charging base against the wall
and connect the power
HEPA filter + sponge
Duster cloth
>1 m
filter
>1 m
>1.5m
Cleaning brush with
Cleaning brush
knife
3. Please do not move the charging base
without reason and keep it out of direct
sunlightsunlight
Left side brush
Right side brush
Advertisement
