Ip Controlled Lighting Setup - Screen Innovations Zero Edge Pro Installation Instructions Manual

IP CONTROLLED LIGHTING SETUP

BACKLIGHT IP OPTION ONLY
Initial Setup:
Before attempting to connect the LED IP to Phillips Hue, ensure that the Hue Bridge is powered on
and connected to the local Wi-FI network.
1. Begin by connecting the power supply to an electrical outlet. After a few seconds, the LEDs will
power on to a white color.
2. Open the Phillips Hue app on a smart device, navigate to "Light Setup" in the "Settings" tab.
3. Press the "Plus" button in the lower right-hand corner, then press "Search."
4. It may take several seconds to connect. Once connected, the LEDs will emit green.
5. The LED IP will appear in the Phillips Hue app as "Extended Color Light 1" and "Dimmable Light 1."
Only use "Extended Color Light 1" to control the LEDs. "Dimmable Light 1" should be deleted.
6. After the LED IP is connected, it can be renamed and used like any Hue lamp.
Reset (Required to connect to a different Phillips Hue):
1. Begin with the LED IP powered on.
2. Turn off for a minimum of 2 seconds.
3. Turn on and wait for LEDs to light up.
4. Repeat the off/on procedure a total of four times.
5. At this point the LEDs will begin blinking for 10 seconds.
6. Once the LEDs stop blinking, repeat the off/on procedure two more times.
7. At this point the LED IP will reset. Once complete, the LEDs will emit a white color.
Note: The LED IP can be connected and controlled by only one Phillips Hue Bridge at a time.
26