Free-Standing Frames; Accessories And Options; Accessories - DeDietrich Innovens MCA 160 Manual

Fig.9 Frames
3.5

Accessories and options

Fig.10 Elbow kit
315 mm
7680446 - v.01 - 14082017
3.4.6
The free-standing frames consist of a combination of I and/or L poles with
an intermediate frame. 1 intermediate frame is required per boiler. The L
poles have bolt holes for fixing to the floor. The frame has two fitting brack­
ets. The top bracket should be used with a MCA 160 boiler and the bottom
bracket for a MCA 45-115 boiler L poles are only required if boilers are
mounted at the rear of the frame (for a back-to-back configuration). Only l
poles are used with linear configurations. The top of the frame can be
used as a cableway. The nuts and bolts required are included with the de­
livery, along with installation instructions. Fastenings for fixing to the floor
are not included.
AD-0000830-01
3.5.1
Elbow kit for angled connection of the low-loss header in 65 and 100
mm diameters
Connecting flanges DN 65 and DN 100 for system side of the low-loss
header
Important
Depending on the system resistance, it may be necessary to
switch to a larger pipe diameter after the connecting flanges of the
low-loss header.
Insulation for low-loss header, low-loss header elbow, connection kits
and main pipes.
DN 65 gas filter
Gas filter expansion piece (for mounting gas filter next to low-loss head­
315 mm
er) DN 65 (to be used if gas filter mounted on the same side as the low-
AD-0000831-01
loss header with elbows or low-loss header with insulation).
Temperature sensor including thermostat pocket for low-loss header.
Adjustable feet
Calorifier connection

Free-standing frames

Accessories

3 Description of the product
MCA 11