NL Troubleshooting
Malfunctions
Faults
There will remain after the
program water in the
appliance.
Device cannot be
switched on or operated.
The device does not start.
Program starts
automatically.
Device hangs in a
program or cuts out.
54
Cause
Sieve system or space below
the sieve is clogged.
Program has not yet
ended.
Device functions
have failed.
Fuse of the house
installation is not OK.
Power cord is not
connected.
Appliance door is not
completely closed.
The program has not
ended.
Appliance door is not
completely closed.
Power and/or water supply
is interrupted.
The upper basket presses
against the inner door and
prevents the appliance door
from closing properly.
Solution
Clean the strainers → Page 42.
1.
2.
Clean the drain pump
→
Page 56.
▶
Wait for the end of the program or
cancel the program with Reset.
→ "Abort program",
▶
Page 39
Unplug the appliance from the
1.
mains socket or switch off the
fuse.
Wait at least 2 minutes.
2.
Connect the device to
3.
the mains.
Switch on the device.
4.
▶ Check the fuse of the house
installation.
Check that the socket is
1.
working.
2.
Check whether the connecting cable is
properly connected to the mains
socket and to the rear of the
appliance.
▶
Close the appliance door.
→ "Abort program",
▶
Page 39
▶
Close the appliance door.
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear wall
▶
of the device is pressed in by
a socket or non-
disassembled hose holder.
▶
Arrange the crockery in such a way
that no crockery parts protrude over
the crockery basket and prevent the
appliance door from closing properly.