Setting Up And Connecting; Package Contents; Setting Up And Connecting The Device; Waste Water Connection - Bosch SM Series Instructions Manual

O
set up and connect
For correct use, connect the
appliance to electricity and water in a
professional manner. Observe the
required criteria and the installation
instructions.
Contents of the package
After unpacking, check all parts for
transport damage and for
completeness of the delivery.
If you have any complaints, please contact
the shop where you purchased the
appliance or our service department.
Note The device has been checked for
correct operation at the factory. Water
stains may remain on the device. The
water spots are gone after the first
wash cycle.
The delivery consists of:
s Dishwasher
s Instructions
s Assembly instructions
s Guarantee
1
s Mounting material
s Steam protection plate
s rubber patch
1
s Power cord
s Quick guide
1
Setting up and connecting the
device
You can install your under- or built-in
appliance in the kitchen unit between
wooden and plastic walls. If you
subsequently install the device as a
free-standing device, you must
secure the device against toppling
over, e.g. by screwing it to the wall or
installing it under
Depending on the device version
1
1
Set up and connect NL
a continuous worktop that is firmly
connected to the adjacent cupboards.
Observe the safety instructions. →
1.
Page 4
Observe the instructions for the
2.
electrical connection.
→ Page 16
The contents of the package
3.
→ Page 15 and the condition of
check the device.
The required installation dimensions can be
4.
found in the installation instructions.
Level the appliance using the
5.
adjustable feet.
Pay attention to a firm position.
Install the waste water connection.
6.
→ Page 15
Install the drinking water
7.
connection. → Page 16
Connect the device to the power
8.
supply.

Waste water connection

Connect the appliance to a drain water
connection so that the contaminated
washing water can be drained.
Install waste water connection
The necessary steps can be found in
1.
the supplied installation manual.
Connect the drain hose to the
2.
connection nipple of the siphon
using the supplied parts.
Make sure that the drain hose is
3.
not kinked, crushed or tangled.
Make sure that the water does not
4.
flow out by a sealing cap in the
waste water connection.
15