Bosch SM Series Instructions Manual page 47

Faults
Crockery is not dry.
Plastic crockery is not No fault. By a bearing
dry.
Cutlery is not dry.
Insides of the appliance
are wet after the wash
cycle.
Cause
The combined
detergent has poor
drying performance.
Extra dry for enhanced
drying is not activated.
Crockery has been removed too
early or the drying process has
not yet been completed.
Used rinse aid has
limited drying
performance.
heat storage capacity
dries plastic worse.
Cutlery is not properly
placed in the cutlery basket
or drawer.
No mistake. For condensation
drying, water drops in the rinse
aid container and the reservoir
are necessary and desirable.
The moisture in the air
condenses on the inner walls
of the device, flows downwards
and is pumped out.
Troubleshooting NL
Solution
Use rinse aid to improve
1.
drying performance.
Use another combination
2.
detergent with better drying
performance.
Activate the Extra Dry option.
▶
Wait for the program end.
1.
Do not remove the dishes until 30
2.
minutes after the end of the
programme.
Use a quality rinse aid
▶
resourse.
Eco-products may have a
limited effect.
No solution available.
▶
Arrange the cutlery correctly.
1.
→
"Clearing crockery",
Page 36
If possible, arrange the cutlery separately from
2.
each other.
Avoid touch points.
3.
No action required. No action
required.
47