Setting Water Softening; Softening Salt - Bosch SM Series Instructions Manual

Water hardness °dH
9 - 10
11 - 12
13 - 16
17 - 21
22 - 30
31 - 50
Note Set the device to the
determined water hardness.
With a water hardness of 0 - 6 °dH you
do not need to use softening salt and
you can switch off the water softening.
Set water softening
Set the appliance to the water
hardness.
Determine the water hardness and
1.
the desired setpoint.
→ "Overview of the water hard-
health settings", page 28
on to press.
2.
press and hold
3.
Pine tree.
Turn the program selector until the
4.
display shows H:04.
Release key.
5.
Turn the program selector until the
6.
desired position is set.
The factory setting is H:04.
on press to save the setting.
7.

Softening salt

You can soften the water with
softening salt.
Filling softening salt
When the Refill softener salt
indicator lights up, fill the softener
salt into the softener salt reservoir
immediately before the program
Hardness range
average
average
average
hard
hard
hard
mmol/l
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9
master start at. The required amount
of softening salt depends on the
water hardness. The higher the water
hardness, the greater the amount of
softening salt required.
PAY ATTENTION!
s Dishwasher detergent can damage the water
damage hardening.
The reservoir of the softener
▶
Only fill the water supply with
special salt for dishwashers.
s The rinse aid container can be
corrode softening salt.
To ensure that
▶
spills softener salt from the
rinse aid container is rinsed, the
softener salt is filled into the
softener salt reservoir
immediately before the program
starts.
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
3. Note Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
Water softening NL
Set value
H:02
H:03
H:04
H:05
H:06
H:07
29