D-Link DIR-822 User Manual page 55

Section 4 - Configuration
Choose L2TP (Layer 2 Tunneling Protocol) if your Internet Service Provider
(ISP) uses a L2TP connection. Your ISP will provide you with a username and
password.
General Settings
Select your connection type.
Connection Type:
Enter name for your connection.
Connection Name:
Toggle this switch to enable the connection. This is enabled by default.
Enable
Disabling this feature may disable your Internet connection.
Connection:
Toggle this switch to enable Network Address Translation (NAT). This
NAT:
setting is enabled by default.
IPsec
Enter your pre-shared key for your connection.
Pre-shared key:
Enable PFS for your connection.
Enable PFS:
Enter the connection port for your connection.
Specify
connection port:
D-Link DIR-822 User Manual
L2TP over IPsec
51