D-Link DIR-822 User Manual page 43

Section 4 - Configuration
Specify the Maximum Transmission Unit of your Internet connection.
MTU:
You may need to change the MTU for optimal performance with your
ISP. The default setting is 1492.
Choose from No encryption, MPPE 40 128 bit, MPPE 40 bit, or MPPE
Encryption
128 bit. No encryption is selected by default.
protocol:
Choose from AUTO, PAP, CHAP, MS-CHAP, or MS-CHAPv2. AUTO
Authentication
is selected by default.
protocol:
Toggle this switch to maintain your connection when no activity is
Keep alive:
detected.
If you have enabled Keep alive, specify the LCP Echo frequency in
LCP interval:
seconds. The default setting is 30.
If you have enabled Keep alive, specify the maximum number of LCP
LCP fails:
fails before the connection is dropped.
Enable this option to automatically dial a PPPoE connection when
Dial on demand:
data flow is detected.
If you have enabled Dial on demand, specify a maximum idle time
Maximum idle
time: in seconds before the connection will be dropped.
Specify extra options if required by your ISP.
Extra options:
Specify the IP address provided by your ISP.
Static IP address:
Toggle this switch to enable PPP debug, this setting is disabled by
PPP debug:
default.
D-Link DIR-822 User Manual
PPPoE IPv6 (cont)
39