Wireless > Advanced Wireless Settings; Advanced Wireless - Cisco Linksys WES610N User Manual

Linksys WES610N/WET610N
Max. Aggregation Size This option defines the maximum size of the
aggregate (in bytes) The range is 0 to 16000 The default is 12000
Timeout Internal This option defines the timeout period in which the
aggregate should be closed with a "closing condition" before it is closed by the
timer The range is 0 to 100 ms The default is 3
Min. Size of Packet in Aggregation
bytes) of packets to be accumulated in the aggregate The range is 0 to 1500
The default is 10
ADDBA Timeout
This option defines the duration after which the ADDBA
setup is terminated, if there are no frame exchanges within this duration by the
Block Acknowledgement (ACK) agreement The range is 0 to 65535 ms The
default is 0, which disables the timeout
Aggregation Window Size
This option defines the maximum number of
packets transmitted without getting ACKs The range is 0 to 64 The default is
64
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes
Voice
Use Aggregation
This option defines whether or not the Media Access Control
(MAC) layer will set up an Add Block Acknowledgement (ADDBA) session The
default is Yes Select No to disable this option
Accept Aggregation This option defines whether or not the MAC layer will
accept an ADDBA request The default is Yes Select No to disable this option
Max. Number of Packets in Aggregation
number of packets (sub-frames) in the aggregate The range is 0 to 2 The
default is 2
Max. Aggregation Size This option defines the maximum size of the
aggregate (in bytes) The range is 0 to 16000 The default is 10000
Timeout Internal This option defines the timeout period in which the
aggregate should be closed with a "closing condition" before it is closed by the
timer The range is 0 to 100 ms The default is 10
Min. Size of Packet in Aggregation
bytes) of packets to be accumulated in the aggregate The range is 0 to 1500
The default is 10
This option defines the minimum size (in
This option defines the maximum
This option defines the minimum size (in
ADDBA Timeout This option defines the duration after which the ADDBA
setup is terminated, if there are no frame exchanges within this duration by the
Block Acknowledgement (ACK) agreement The range is 0 to 65535 ms The
default is 0, which disables the timeout
Aggregation Window Size This option defines the maximum number of
packets transmitted without getting ACKs The range is 0 to 64 The default is
64
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes
Wireless > Advanced Wireless Settings
Configure the bridge's advanced wireless functions These settings should
only be adjusted by an expert administrator as incorrect settings can reduce
wireless performance
NOTE
The settings on the Advanced Wireless Settings screen are designed
for advanced users only

Advanced Wireless

Use LDPC Low-Density Parity-Check Code (LDPC) enables or disables error
correction to reduce the probability of data loss in noisy channels The Rate
Adaptation algorithm automatically disabled LDPC coding when working at
high PHY rates (higher than 162) To use the LDCP advanced error correction
scheme, keep the default, Yes Otherwise, select No
Advanced Configuration
13