RGBlink Q16pro Quick Start Manual page 16

Layer
Layer number: Numbers in the corner is to show how many
layers at present allowed to put in the output.
A 2K signal occupies one layer, and a 4K2K60 signal occupies
four layers
The number in the red rectangle on the right figure represents
the number of layers that can be placed at the output.
Layer Adjustment
there are two ways to adjust layer.
1. Use the bar under the interface
Choose one layer and the bar shows its signal source, type in
position and size.click Set to confirm.
2. Layer Scale and Crop
Choose one layer needed to be adjusted,and type in its
position and size.
this icon means data related, when width is changed,
height will be changed as same proportion.
this icon means data not related, width and height need to
be filled respectively.
Layer Movement
Place the cursor on the layer, it turns to a palm icon
left of mouse, the icon turns to a fist
drag the layer.
Layer Remove
Click the cross on the top right of the layer to remove the layer if
needed.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197 | support@rgblink.com | www.rgblink.com
, press the
, moving the mouse can
15