Fbt VAIE 7M00 Series Instructions For Use Manual page 86

EN
Label
Control input
Output
Application
Controlled input contacts
Relay outputs
VAIE 7M00
See panel
38
Notes
Panel for confi guring the controlled
inputs. To go from one input to
another (from 1 to 7), press Next
or Prev.
Press Mode to select one of the
following modes:
- Message input > Edit zone
- Broadcast > Edit zone
Press 'Edit zone' to associate a
message with each zone
- Not active input
- Reset input
Press Control to enable or disable
control over the concerned input.
Press Logic to set the logic
typology attributed to the
concerned input, choosing
between:
- Positive (active high)
- Negative (active low)
Press Trans to choose the
operating mode:
- Level: the messages are
activated only for as long as the
input is activated.
- Transition: activation of the
messages starts with activation of
the input, but can be stopped only
by means of manual resetting or a
reset input.
Press 'Escape' to exit the screen
page.
Panel for confi guring the outputs.
To go from one output to another
(from 1 to 3), press Next or Prev.
Activate or de-activate (On/Off ) the
type of event to be associated with
the output in question by pressing
the appropriate buttons.
To leave the screen, press
'Escape'.