Reassembly T-900 & T-1200 Cylinder - Dexter Laundry T-300 Service Procedures And Parts Data

Machine Service Procedures
Reassembly T-900 & T-1200 Cylinder
Step 1: Use the hub of the
drive pulley, a stack of 5/8"
fl at washers and a 3" long
5/8" bolt to pull the cylinder
shaft through the bearings.
After the 3" bolt a 2" long
bolt will be required to fi n-
ish pulling the cylinder shaft
through.
Step 2: Remove the 1/2" bolt
and nut from the top of the
outer tub clamping band.
Step 3: Install Dexter Tool
part # 8545-056-001 on
the back of the outer tub to
adjust tub front to cylinder
clearance.Thread 5/8" bolt
through tool and into cylin-
der shaft. Push the outer tub
forward 1/4" to 1/2" with tool
8545-056-001by tightening
the 5/8" bolt. This will ease
the installation of the outer
tub front.
Step 4: Clean the silicone
rubber off the tub front and
the outer tub.
Step 5: Install new bead of
silicone rubber on tub front.
Step 6: Install tub front.
Step 6A: Align hole in
top of tub front with notch
in top of outer tub.
58
Step 6B: Use 4-6 #11R vise
grip clamps to hold tub
front to outer tub. A rubber
mallet may be needed to
properly seat the tub front into
the outer tub.
Step 6C: Install tub front
gasket around outer edge
of tub front and outer tub
fl ange. The opening should be
centered at the top.
Step 6D: Remove vise grips.
The tub front gasket will hold
the tub front in place.
Step 7: Install tub front clamp
ring and tighten. Tap around
the clamp ring with a rubber
mallet to seat the ring and
gasket while tightening the
clamp ring bolt.
Step 8: Adjust clearance
between the outer tub front
and the front lip of the cylinder
to 5/16".
Step 9: Tighten the outer tub
clamping band.
Step 10: If necessary, the
outer tub may be adjusted
up or down and side to side
with the 2 bolts that fasten
the bottom of the outer tub
clamping band to the frame.
Step 11: Remove Dexter
Tool part 8545-056-001 from
the back of the outer tub.
Step 12: Install drive pulley.
Step 12A: Install hub on
cylinder shaft.
Step 12B: Hold hub
against rear bearing with
5/8" bolt and fl at washer in
end of cylinder shaft.
Step 12C: Line up 3
unthreaded holes in pulley
with the 3 threaded holes in
hub.
Step 12D: Insert 3 pulley
bolts and tighten evenly
alternating bolts to 30ft/lbs.
Note: Overtightening or
uneven tightening can
break drive pulley.
Step 13: Install drive belts &
back panel.
Step 14: Install door lock. All
mounting holes should be
sealed with silicone rubber.
Step 15: Install door,
masking ring, front panel,
lower service panel and top.