Loading Door Disassembly; Loading Door Reassembly; Control Panel Name Plate Decal; Name Plate Removal - Dexter Laundry WN0675 Parts And Service Manual

Loading Door Disassembly

Step 1: Remove the loading door
as outlined above. Lay
the door on a flat surface
with the glass down

Loading Door Reassembly

Step 1: Lay the door ring face
down on a flat surface.
Start the glass into one
side of the door gasket.

Control Panel Name Plate Decal

The name plate on washer front is adhesive backed.
Control Panel Name Plate Removal
The name plate may be removed by simply peeling it off.

Re-Installation of Name Plate

Step 1: Remove any remaining glue from the control panel.
Step 2: Before removing the paper backing from the name plate, check fit to the control panel. The program
push buttons are the locating guides.
Step 3: Remove the paper backing from the right side of the name plate, position it on the panel and press
right end into place. Peel the backing from the left end and press into place.
62
Part # 8533-126-001 11/21
Step 2: While holding down on
the door glass, lift up
on the door ring and roll
back the lip of the gasket
with your fingers.
Step 2: Use one hand
underneath to push the
gasket out and the other
hand on the top pulling
the gasket in place
Step 3: Work all the way around
the gasket and the glass
is out.
Step 3: The front lip of the
door gasket should
be checked for proper
seating.