Drain Valve Access - Dexter Laundry T-300 Service Procedures And Parts Data

Machine Service Procedures
Lower Service Panel Removal
Remove 2 screws and pull forward to disengage from the locator studs.
Note: Before performing any service work, remove electrical power from the machine.
Always replace panels before putting machine into service.
Top Panel Removal
Step 1: Remove 4 screws that hold detergent dispenser to top panel.
Step 2: Unlock top panel lock.
Step 3: Raise top panel, slide to the rear to release from back clips and lift off.
Front Panel Removal
Step 1: Remove 2 screws between front panel top and front (located behind control panel).
Step 2: Remove the two screws in the middle of the front panel.
Step 3: Pull panel out at the bottom to about a 45 degree angle to detach the top lip and remove.
Back Panel Removal
Step 1: Remove all screws holding back panel in position except the bottom row.
Step 2: The bottom row of screws are slotted and only need to be loosened and to lift off panel.
Note: The back panel is not only a safety requirement but also contributes to the rigidity of
the cabinet.

Drain Valve Access

For access to drain valve, remove lower service panel. The drain valve is a ball type and is
powered closed by the drain valve motor. It is mounted under the washer tub on the left side. It
is spring loaded open. If power is interrupted to the washer, the motor releases the sealing ball,
allowing the drive spring to open the valve. With the valve open, all water in the washer will drain
out.
42