75 Pound Water Seals; Outer Tub T-900 & T-1200 - Dexter Laundry T-300 Service Procedures And Parts Data

55 & 75 LB. Water Seals
Replacement
Guard Ring & Mating Ring
Step 1: Remove cylinder from washer (see Cylinder (basket) removal).
Step 2: Remove water seals from the seal mounting plate on the cylinder shaft. These are
removed with your fi ngers.
Step 3: The primary and secondary seals that mount on the sealing ring may be slid over
the shaft and seated on the metal sealing ring with your fi ngers. In the unlikely event that the
metal ring that mounts these sealing rings were to be damaged or moved, a new one would
need to be pressed on. The seal mounting ring must be pushed against the stop on the
shaft. After installing the seals, lubricate the faces of the seals with silicone grease.
Step 4: Install cylinder (see Cylinder (basket) reassembly).
Outer Tub T-900 & T-1200
Removal
Step 1: The outer tub can easily be removed when the tub
front, cylinder and bearing housing has been removed as
outlined previously.
Step 2: At that point the only attachments to the chassis
are the two front strap mounting bolts.
Machine Service Procedures
Seals Mating Ring & Mounting Ring
57