Protek 3201 User Manual page 45

HOLD MODE
HOLD MODE
OFF
OFF
DELAY RUN
DELAY RUN
DELAY HOLD
DELAY HOLD
HOLD STOP
HOLD STOP
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
Hold mode disabled. Scanning stops when the signal level amplitude
is greater than the Squelch level and restarts when the signal level
amplitude drops below the Squelch level.
Scanning will stop when received signal level amplitude is greater
than the squelch level and then restart after the hold time
(approximately 5 seconds) if the signal level amplitude remains
greater than the squelch level. If the signal level drops below the
squelch level during the hold period scanning will restart.
Scanning will stop when a received signal level amplitude is greater
than the squelch level then restart after the hold period, irregardless
of the signal level value during the hold period.
Scanning will halt when the signal level is greater than the squelch
level and will remain stopped. Pressing the
the scan.
FAX 781.665.0780 - TestEquipmentDepot.com
key will restart