Protek 3201 User Manual page 10

Input impedance
Max.Input voltage
Audio output
Level Measurement
N-FM mode Range
Resolution
Accuracy
Repeatability
Bandwidth
W-FM/AM/SSB Range
Resolution
Accuracy
Repeatability
Bandwidth
Spurious and Noise Level internally generated
Functions
Display modes
Sweep modes
Scan modes
Hold modes
Level hold modes
Squelch function
Copy function
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
: 50Ω (standard)
: Max. 5V RMS
: 120mW into 8Ω speaker
: -70 to –20dBmV(-10 to 40dBµV)for 300 to 1800MHz
-60 to –20dBmV(0 to 40dBµV)for 1 to 300MHz and 1800 to 2000MHz
: ±0.5dBµV
: ±3dB(at an ambient of temperature of 23℃±3℃)
: ±2dB
: Approx. 12.5KHz(-6dB)
: -60 to –10dBmV(0 to 50dBµV)for 300 to 1800MHz
-50 to –10dBmV(10 to 50dBµV)for 10 to 300MHz and 1800 to 2000MHz
: ±0.5dBµV
: ±3dB(at an ambient of temperature of 23℃ ± 3℃)
: ±2dB
: WFM: Approx. 180KHz(-6dB), AM/SSB:Approx.2.4KHz(-6dB)
: -45dBc for N-FM typical, below a full scale signal level frequency.
: Spectrum display
Multi Bar graph display(5, 10, 20, 40, 80, 160CH)
Single Bar graph display
Difference frequency display
Frequency measurement level display
: Single, Normal, Free Run, Free Single
: Manual, CH.Memory and Search scan
: Delay run, Delay hold and delay stop
: Max. Hold, Hold, 40mS, 100mS and 200ms peak hold
: Squelch level is displayed as a bar graph and a digital Readout. The
squelch level may be adjusted to any value from the reference level to
Full scale
: The copy set mode allows the contents of the Channel edit, Setup and
Data memories to be copied to an external device. Data may also be
written in to these memories from an external device.
FAX 781.665.0780 - TestEquipmentDepot.com
: -35dBc W-FM