Table of Contents
Advertisement
[3] To select Alphanumeric characters for a channel name press the
rotary dial Knob until the desired character is displayed.
F1
Press the
procedure until all characters are entered.
Note:
Numeric characters from
[4] Pressing the
ENTER
figure in section 5-1.
[5] Example: To enter the Channel name NHK: 1 in to the channel memory use the
following procedure: (See the below figure.)
F1
[1] Press the
the dial knob until the letter of 'N' appears in the reversed contrast cursor block.
F1
[2] Press the
the dial knob until the letter of 'H' appears in the reversed contrast cursor block.
[3] Enter the remaining of the characters in the channel using steps 1 and 2
[4] Press the
CLR/.
memory.
Note:
When the
Will advance to the next position to the right.
key to advance the cursor to the next character position and repeat the
0
key will store the channel name into memory as shown in the
key to highlight the
key to enter the second character. Press the
key after the last character in the Channel name to store the name in
Key is pressed a space will be entered as a character and the cursor
CLR/.
to
may also be entered from the keypad.
9
NAME
icon. Press the
31
31
key of rotate the
key or rotate
key or rotate
Advertisement
Table of Contents
