New In This Release; Prerequisites And Requirements; Product Support - ABB LD 800HSE Manual

New in This Release

It is also possible to configure and commission an FF network which is not linked to
an IEC 61131 controller.
New in This Release
•
•

Prerequisites and Requirements

Before commissioning of LD 800HSE make sure to use the latest linking device
firmware released for your system environment.
It is required that all applicable revisions and rollups for your system are installed
either previously or at the same time this firmware is installed. Industrial IT
System 800xA SV 5.x System Software Versions (3BSE037782R5001) lists all the
revisions and rollups released for the above system version and includes links to
the revisions and rollups and associated release notes.
Refer to the LD 800HSE and LD 800HSE EX Version Table (3BDS009910) in the
ABB SolutionsBank to find out the latest linking device firmware released for
your system environment.
For obtaining firmware and capabilities file, refer to
Installation.

Product Support

Contact ABB technical support for assistance in reporting the problem.
20
Increase in security of linking device - Linking Device web server is password
protected and must be changed from the default password.
Zone 2 Environment - Support of Linking device type LD 800HSE EX on Zone
2 Explosion and Protection Environment.
Section 1 Introduction
Section 2, Hardware
3BDD011677-600 A