ABB LD 800HSE Manual page 51

Section 3 Configuration
Step 2: Configure your PC in such a way that you have access to the network
192.168.1.0. For this purpose, you may have to assign your PC a second IP address
(e.g. IP address = 192.168.1.100, net mask = 255.255.255.0, broadcast =
192.168.1.255), refer to
To assign a new IP address to your PC, you must have administrator rights.
Step 3: Try to ping the linking device. Open a DOS box and enter the following
command: 'ping 192.168.1.20'. The linking device must respond.
If it does not respond you should proceed as follows:
•
•
•
Step 4: If you have access to the linking device from your PC, you can change its
network configuration with a web browser, refer to
3BDD011677-600 A
Setting Up an IP Connection between PC and Linking Device
Assignment of a Second (Local) IP Address
Check whether the linking device is correctly connected to the LAN and
whether it is switched on.
Check also whether your PC is correctly connected to the LAN by a cable.
Check whether the PC has been configured with a valid IP address from the
subnet 192.168.1.0. Try to ping the second (local) IP address of your PC (in the
example, 192.168.1.100). If the local host does not respond, the second IP
address has not been initialized correctly.
on page 52
Firmware Update on page 65
51