Programming With Ad Card; Using An Ad Card To Load Ads; Procedure To Program The Ad - Bunn ITB/ITCB Programming Manual

Bunn coffeemaker user manual
Table of Contents

Advertisement

Using an AD CARD to load ADS:

The information is loaded into the brewer's memory
by holding the chip area up to the brewer's SENSING
COIL.
NOTE: Instructions to program the brewer are printed
on the AD CARD.

Procedure to program the AD:

1. Remove the funnel(s) if present.
2. Position the RECIPE CARD vertically, so that the
top end of the CHIP is beneath the (Left on Twins)
SENSING COIL (located on the underneath side of
the front display panel).
3. After a short pause the display will read CARD
CONTAIN ADS/SHOW-QUIT-SAVE.
4. To show (view) this information, select "SHOW".
The display will scroll through all of the ad on that
chip. The display will then return to CARD CONTAIN
ADS/SHOW-QUIT-SAVE.
5. If message is correct, press SAVE. The display will
read AD MESSSAGE SETUP COMPLETE. The ad is
now stored in the brewer's memory.
6. If the ad is not correct, or it is desired to exit the
setup before the ad is loaded into the brewer's
memory, press QUIT. The display will then return
to the MAIN SCREEN.

PROGRAMMING WITH AD CARD

NOT AVAILABLE ON ITB
Page 10
READY TO BREW
WATER TEMP XXX°
POSITION CARD UNDER
SENSOR COIL
CARD CONTAIN ADS
SHOW QUIT SAVE
SCROLLS THROUGH
AD MESSAGE
COMPLETE MESSAGE
SETUP COMPLETE
READY TO BREW
WATER TEMP 200°
NOTE: ENABLE ADS must be
turned on in LEVEL 2 in order
for the newly programmed ad
message to be displayed.
41581.2 091609

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Infusion itb/itcbInfusion icb/twin

Table of Contents