Set New Coffee Items; Procedure For Setting The Recipe - Bunn ITB/ITCB Programming Manual

NOT AVAILABLE ON ITB
* SET NEW RECIPE (COFFEE ONLY)
To set a new COFFEE recipe using a Smart Funnel
and a G9-2T DBC or MHG Grinder:
This function allows the operator to set BREW VOL-
UMES, BYPASS %, PULSE BREW/PREINFUSION
TIMES AND DRIP OUT TIMES for each coffee name
stored in the grinder's memory.
Certain coffee names are stored in the grinder's memory.
When a particular name of coffee is ground into the
Smart Funnel, that name and the batch size selected
are transferred from the grinder to the programming
CHIP located in the funnel handle. The funnel is then
inserted into the brewer's funnel rails. The SENSING
COIL on the brewer reads the information contained in
the handle. The name of the coffee flavor will then ap-
pear on the display. This allows the operator to set the
BREW VOLUMES, BYPASS % (N/A on ITCB), PULSE
BREW/PREINFUSION TIMES AND DRIP OUT TIMES for
that particular coffee name. Each coffee name can be
set individually to provide optimum brewing quality.

SET NEW COFFEE ITEMS

ICB
Brew Ounces
% Bypass
Pulse Brew/Preinfusion Times
Drip Times
* ITCB WITH FACTORY SWEETENER

Procedure for Setting the Recipe:

NOTE: Before beginning setup, place a server beneath
the brew funnel.
1. Insert the funnel into the grinder and select the
small batch size to grind. It is not necessary to have
coffee beans in the hopper(s) in order to program
the brewer. The coffee name is pre-selected and
stored in the grinder's memory for the side being
ground.
2. Press the GRIND switch. When the grinder stops
grinding, remove the funnel.
3. On the brewer, press and hold the right hidden
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
ITCB
Dilution Ounces
Dilution Delay Time
* SWEET METER
switch until the display reads SET LANGUAGE.
Press and release the right hidden switch until the
display reads SET NEW RECIPE.
4. Select YES. The display should read INSERT FUN-
NEL WITH NEW NAME, then QUIT SETUP? These
two displays will repeatedly cycle.
5. Insert the funnel into the rails on the brewer (Left
on Twins). The display should read the name of
the coffee that was ground into the funnel, along
with a NO and YES. If the name on the display is
correct, press YES.
6. If, for some reason, the name of the coffee from
the grinder did not load properly into the funnel,
or if a grind has not yet been done, the display will
read MUST GRIND INTO FUNNEL FIRST. It will be
necessary to grind another batch following steps
1, 2 & 5.
NOTE: If brewer memory is full, the display will read
RECIPE STORAGE AREA IS FULL and then REMOVE
A FLAVOR? To remove a recipe press and release
YES. Press NEXT to scroll through the stored recipes.
When the display reads the name of the recipe to be
removed, press and release REMOVE. The display
will read REMOVE? Press CANCEL to exit the SET
NEW RECIPE function. Press OK to remove that
recipe. The display will then show BEGIN SETUP
OF (COFFEE NAME).
7. If the grind is acknowledged by the brewer, the
display will read BEGIN SETUP OF (COFFEE NAME).
Then the screen will display BREW OZ and a batch
light will be blinking. Follow steps on page 11
(Review Recipes) to adjust recipe settings.
Page 18
41581.2 091609