Procedure To View/Reset The Brew Counters - Bunn ITB/ITCB Programming Manual

* BREW COUNTERS
This function allows the operator to track the total num-
ber of brew cycles completed, as well as the number of
batches brewed using each of the brew buttons. There
are (up to) six resettable counters, and one life counter
that is not resettable.

Procedure to view/reset the brew counters:

1. Press and hold the right hidden switch until the
display reads SET LANGUAGE. Press and release
the right hidden switch until the display reads BREW
COUNTERS.
2. Pressing NO will advance to the next programming
function. Select YES to view the first brew counter
(TOTAL LIFE BREWS). This number represents the
total number of brew cycles this brewer has com-
pleted. This counter is non-resettable. Press NEXT
to advance to the next brew counter, <- <- BREW
A (left side).
3. This counter represents the number of brews for
Brew A on the left side of the brewer. To reset the
counter to zero, press and release RESET. Press
and release NEXT to advance to the next counter.
4. Repeat step 3 for the remaining two left counters,
BREW B and BREW C.
5. Repeat step 4 for the three right side brew counters.
(Twin only)
6. When finished, press NEXT to advance to the next
programming function, ENTER ASSET #. To exit
programming and return to the MAIN SCREEN,
press ENABLE BREW ON/OFF switch.
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
PRESSING NO WILL
ADVANCE TO
ENTER ASSET #
ICB Twin
shown.
ITB/ITCB
similar
Page 26
BREW COUNTERS?
NO YES
TOTAL LIFE BREWS
XXXX NEXT
<- <- XXX BREW A
RESET NEXT
<- <- XXX BREW B
RESET NEXT
<- <- XXX BREW C
RESET NEXT
BREW A XXX -> ->
RESET NEXT
BREW B XXX -> ->
RESET NEXT
BREW C XXX -> ->
RESET NEXT
ENTER ASSET #?
NO YES
41581.2 091609