Table of Contents
Advertisement
Replacing the Keyboard
You need a small Phillips and a small flat-blade
Tools
screwdriver to replace the keyboard.
Preventing static electricity discharge
The components inside your notebook are extremely sensitive
to static electricity, also known as electrostatic discharge (ESD).
ESD can permanently damage electrostatic discharge-sensitive
components in your notebook.
To avoid exposure to dangerous electrical
voltages and moving parts, turn off your
Warning
notebook and unplug the AC adapter, modem
cable, and network cable before replacing a
component.
Before working with notebook components, follow these
guidelines:
•
Avoid static-causing surfaces such as carpeted floors,
plastic, and packing foam.
•
Remove components from their antistatic bags only when
you are ready to use them. Do not lay components on the
outside of antistatic bags because only the inside of the
bags provide electrostatic protection.
•
Always hold components by their edges. Avoid touching
the edge connectors. Never slide components over any
surface.
•
Wear a grounding wrist strap (available at most electronics
stores) and attach it to a bare metal part of your workbench
or other grounded connection.
•
Touch a bare metal surface on your workbench or other
grounded object.
Removing the old keyboard
To remove the old keyboard:
1 Follow the guidelines under "Preventing static
electricity discharge."
2 Turn off your notebook.
3 Disconnect the AC adapter, modem cable, and
network cable.
4 Disconnect all peripheral devices and remove any
Express cards.
5 Turn your notebook over so the bottom is facing up,
then remove the battery. For more information, see
"Changing Batteries" in your online hardware guide.
6 Remove the two keyboard cover screws located in
the battery compartment.
Screw
Technical Support
See the label on the bottom of the notebook for Customer
Care Information. See your hardware guide for important
safety, regulatory, and legal information.
Screw
www.gateway.com
7 Turn the notebook over so the top is facing up.
8 Carefully open the LCD panel to the fully opened
position.
9 Insert the small flat-blade screwdriver or
non-marring tool under both the right and left
hinge cover and gently pry them up.
10 Pull the old cover off the notebook. You will hear
small snapping sounds as the cover comes away
from the notebook.
11 Gently lift the back edge of the keyboard.
12 With the back edge of the keyboard raised, carefully
push it toward the LCD panel to release the keyboard
retaining tabs. Be careful not to damage the LCD
panel.
13 Rotate the keyboard toward you so it lies keys-down
on top of your notebook.
© 2006 Gateway, Inc. All rights reserved. Gateway and
eMachines are trademarks or registered trademarks of
Gateway, Inc. in the United States and other countries.
All other brands and product names are trademarks or
registered trademarks of their respective companies.
Replacing the Keyboard
1
Advertisement
Table of Contents
