Table of Contents
Advertisement
No.:GC-JS-21
5
Button Battery
6
Leak check
9.3.3 Maintenance plan
序号
Maintenance items
1
Bacteria filter replacement
2
Door seal replacement
3
Printer paper replacement
4
Replace the button battery
9.3 Detail method
9.3.1 Sterilization chamber cleaning: wipe the sterilization chamber wall and sealing surface with a clean towel
dipped in water.
Do not use acidic or alkaline cleaning agents to clean the sterilization chamber.
Before cleaning the sterilization chamber, please confirm that the sterilization room has been
to avoid burns.
9.3.2 Cleaning the water storage tank
First drain the water in the water tank, then wipe the inner wall of the water tank with a clean towel, and remove
the dirt in the water tank.
Do not remove the filter of the water storage tank when cleaning the water tank to prevent dirt from
entering the pipeline, causing the pump to fail and alarm.
9.3.3 Drain filter cleaning
There is a drainage filter at the front of the sterilization chamber;
Turn counterclockwise to remove the drain filter in the sterilization chamber;
Unscrew the internal pressure ring of the drainage filter;
Clean the 2 filters inside;
Reassemble the filter: Note that the filter with the thick mesh is put in first, then the one with the fine mesh, and
then screwed in the pressure ring.
Screw the drain filter into the sterilization chamber.
Version: 01/00
Every half year
For the first time
every day
Cycle
Every 150 times
Every 2 years
When the printer
is out of paper or
is about to run out
of paper
Every 2 years
Effective date：2020-03-30
The date and time are correct
The result is qualified
Requirement
Insert firmly
The wide side faces outwards, and
the sealing ring is flat
The thermal side of the paper is
facing up, no paper jam
The date and time are correct, and
the date and time are correct 5
minutes after power off
Refer to 9.3.10
Refer to 9.3.11
Remark
Refer to 9.3.12
Refer to 9.3.13
Refer to 9.3.14
Refer to 9.3.15
cooled
32
Advertisement
Table of Contents
