Viessmann Vitocrossal 200 Service Instructions Manual page 36

Initial start-up, inspection, maintenance
Burner control unit
Setting
Rated burner output
Parameter set 4
246 kW
Parameter set 5
311 kW
Acknowledging a parameter set
A flashing "P" is shown under "Status", if a parameter set is changed via the DIP
switch or if the burner control unit has been replaced. The figures under Service
show the set parameters (see page 35).
"U" will appear under "Service" if an invalid DIP switch setting is selected.
1. Check the DIP switch setting; if
required, change it in accordance
with page 35.
36
(cont.)
Setting
Reduced burner output
Parameter set 10
173 kW
Parameter set 11
218 kW