Table of Contents
Advertisement
Models 59 and 59-T Evacuation Chair
4.3 Ankle Restraint
Attach the two-piece ankle restraint to the front legs of
the chair.
To attach the restraint:
1. Unbuckle the restraint to separate the straps.
2. Wrap a strap around one front leg of the chair
and thread the buckle through the loop (Figure 4).
3. Pull the strap until the looped end is tight around
the chair leg (Figure 5).
4. Attach the remaining strap to the other front leg
of the chair.
5. Buckle the restraint and adjust the length (Figure 6).
4.4 Attaching Restraints to Chair
With Soft Vinyl Seating
With soft vinyl seating, use the criss-cross restraint
configuration plus a lap restraint (Figure 2, page 10).
Attach restraints as follows:
1. Unbuckle a restraint to separate the straps.
2. Attach the strap with the female buckle piece to
the left or right side of the backrest frame (Figure
7). Follow instructions in the restraint users'
manual for attaching a two-piece restraint.
3. Attach the strap with the male buckle piece to the
exposed area of the seat frame on the opposite
side of the chair.
4. Repeat steps 1-3 to attach the second torso
restraint.
5. Attach a lap restraint alongside the restraints already
attached to the seat frame.
6. Fasten and adjust the restraints.
© Ferno-Washington, Inc. 234-3298-01 October 2005
Figure 4 - Threading Buckle Through Loop
Figure 5 - Tightening Strap
Figure 6 - Ankle Restraint Attached
Figure 7 - Torso Restraints on
Chair with Soft Vinyl Seating
Chair Setup
11
Advertisement
Table of Contents
