Models 59 and 59-T Evacuation Chair
Maintenance
7.10 Removing and Attaching
The ABS Panels
The molded ABS seat and backrest panels snap on and
off the chair frame.
BACKREST PANEL
To remove the backrest panel: gently pull downward
on the flange near one bottom corner and pull the corner
of the panel away from the chair (Figure 41). Repeat at
the opposite corner. Then slide the panel up off the two
keepers at the top of the frame (Figure 42).
To attach the backrest panel: Orient the panel with
the horizontal restraint slots uppermost. Slide the two
holes in the top flange down over the keepers on the
top of the backrest frame, then press both lower corners
of the panel against the sides of the frame until they
snap into place over their keepers.
Figure 41 - Releasing a Bottom Corner
SEAT PANEL
Of the Backrest
To remove the seat panel: Pull upward on the panel
flange at each front corner to pop the panel free of the
seat frame (Figure 43) then lift the panel off the chair.
To attach the seat panel: align the panel with the chair
frame and press down to snap the panel onto the frame.
Figure 42 - Lifting the Backrest Panel
Over the Keepers
Figure 43 - Releasing a Corner
Of the Seat Panel
© Ferno-Washington, Inc. 234-3298-01 October 2005
29