Table of Contents
Advertisement
Maintenance
7.11 Removing and Attaching
The Soft Vinyl Seating
To remove the seating:
1. Unfasten the snap at each corner of the vinyl at
the top of the backrest (Figure 44).
2. Lay chair on its back and unbuckle both retaining
straps beneath the seat (Figure 45).
3. Unfasten the four snaps on the vinyl flap beneath
the seat at the front of the chair (Figure 46).
4. Lift the cover off the chair and return the chair to
the upright position.
To attach the seating:
1. Fasten the snap at each corner of the vinyl at the
top of the backrest.
2. Lay chair on its back and fasten the buckles of
both retaining straps.
3. Fasten the four snaps on the vinyl flap beneath
the seat at the front of the chair.
4. Pull the free end of each buckled retaining strap
until the strap is tight (Figure 47), then return the
chair to the upright position.
30
Models 59 and 59-T Evacuation Chair
Figure 44 - Unfasten Snaps
Figure 45 - Unbuckle Straps
Figure 46 - Unfasten Seat Snaps
Figure 47 - Tighten Straps
© Ferno-Washington, Inc. 234-3298-01 October 2005
Snaps
Snaps
Advertisement
Table of Contents
