What If There Are Problems; Disposal - Beurer BM 81 easyLock Instructions For Use Manual

10. What if there are problems?

Error Possible cause
message
Unable to record a pulse.
Er1
You moved or spoke during the measure
Er2
ment.
The cu is not attached correctly.
Er3
The measured values are outside the speci
Er4
ed measurement range.
An error occurred during the measurement.
The in ation pressure is higher than 300
Er5
mmHg.
The batteries are almost empty.
Er6
Unable to transfer the data via
ER7

11. Disposal

Repairing and disposing of the device
• Do not repair or adjust the device yourself. Proper operation can no longer be guaranteed in this case.
• Do not open the device. Failure to comply will invalidate the warranty.
• R epairs must only be carried out by Customer Services or authorised retailers. Before making a claim,
please check the batteries first and replace them if necessary.
• For environmental reasons, do not dispose of the
device in household waste at the end of its service life. Dispose of the device at a suitable local
collection or recycling point in your country. Dispose of the device in accordance with EC Directive
– WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please contact the local
authorities responsible for waste disposal.
Disposing of the batteries
• The empty, completely flat batteries must be disposed of through specially designated collection boxes,
recycling points or electronics retailers. You are legally required to dispose of the batteries.
Solution
Please wait one minute and repeat the mea
surement.
-
Ensure that you do not speak or move during
the measurement.
Please observe the information in chapter
„Attaching the cu " and take another measu
rement after one minute.
- Please wait one minute and repeat the mea
surement.
Ensure that you do not speak or move during
the measurement.
If the error occurs repeatedly, consult a doc
tor to check you are healthy.
Please take another measurement to check
whether the cu can be correctly in ated.
Make sure that neither your arm nor other
heavy objects are pressing on the line, and
that the line is not bent.
Insert new batteries into the device.
Bluetooth . Please observe the information in chapter
®
"Transfer of measurements via
32
-
-
-
-
Bluetooth ".
®