Blower & Collector Removal - Ferris SNAPPER PRO FAST-Vac Operator's Manual

BLOWER & COLLECTOR
REMOVAL
1. Remove the knobs (A, Figure 38) securing the
deck guard top (B) to the deck guard.
2. Pull the blower idler arm lever (C) forward to
release the belt tension and remove the belt from
the spindle pulley.
3. Reinstall the deck guard top and secure with the
knobs.
4. Loosen the lower clamp (A, Figure 39) securing
the hose to the blower outlet and remove the hose
from the blower.
5. Pull the quick pins on the blower mount and
remove the blower from the mower deck.
6. Re-install the deflector plate (C,
mower deck and secure using the hardware that it
was removed with.
7. Reinstall the discharge chute (A, Figure 40) and
secure with the chute mount rod (B) and hardware
that you retained with the discharge chute.
8. Empty the grass collector bags and reinstall in the
bagger frame.
9. Remove the hitch pins (B, Figure 41) securing the
bagger mount posts (A) to the mount plate.
10. Lift the bagger unit up and off of the mount plate.
Figure 38. Remove the belt
A. Knob
B. Deck Guard Top
C. Idle Arm Lever
Figure 40) to the
A
A
B
C
Blower & Collector Removal
A
Figure 39. Remove the Hose
A. Lower Clamp (w/ knob)
B
A
Figure 40. Reinstall the Discharge Chute and
Deflector Plate
A. Discharge Chute
B. Chute Mount Rod
C. Deflector Plate.
A
B
Figure 41. Remove the Hitch Pins
A. Mount Post
B. Hitch Pin
C
27