Blower & Collector Removal - Ferris FAST-Vac Operator's Manual

Removal
BLOWER & COLLECTOR
REMOVAL
1. Remove the knobs (A, Figure 34) securing the
deck guard top (B) to the deck guard.
2. Pull the blower idler arm lever (C) forward to
release the belt tension and remove the belt from
the spindle pulley.
3. Reinstall the deck guard top and secure with the
knobs.
Figure 34. Remove the Belt
A. Knob
B. Deck Guard Top
C. Idler Arm Lever
4. Loosen the lower clamp securing the hose to
the blower outlet and remove the hose from the
blower. See Figure 35.
5. Pull the quick pins on the blower mount and
remove the blower from the mower deck.
A
Figure 35. Remove the Hose
A. Lower Clamp (with knob)
22
A
A
B
C
6. Re-install the deflector plate (C, Figure 36) to the
mower deck and secure using the hardware that it
was removed with.
7. Re-install the discharge chute (A) and secure with
the chute mount rod (B) and hardware that you
retained with the discharge chute.
8. Empty the grass collector bags and reinstall in the
bagger frame.
B
A
Figure 36. Reinstall the Discharge Chute
A. Discharge Chute
B. Chute Mount Rod
C. Deflector Plate
9. Remove the hitch pins (B, Figure 37) securing the
bagger mount posts (A) to the mount plate.
10. Lift the bagger unit up and off of the mount plate.
11. Remove the weights from the weight carrier.
A
B
Figure 37. Remove the Hitch Pins
A. Mount Post
B. Hitch Pin
www.ferrismowers.com | www.snapperpro.com
C