Table of Contents
Advertisement
Installation
Collector Installation
Install Collector Mount Plate
Identify and follow the correct procedure for your unit.
(1000Z & IS1000Z Series)
1. Remove the hardware securing the rear bumper
screen (A, Figure 24) to the top and bottom
bumpers (A, B). Save the 3/8" bolts and washers
from the lower bumper.
2 .Install the collector mount plate (Figure 25) on to
the lower bumper and secure with the previously
removed 3/8" bolts, 3/8" washers (B) and new 3/8-
16 nylock flange nuts (E).
3. Install the 3/8-16 x 1-1/2" bolts and 3/8" washers
(C) through the top mount holes as shown in
Figure 26. Install the support bar (D) and secure
with the 3/8-16 nylock flange nuts (E).
18
C
Figure 24. Remove Bumper Screen
A. Screen
B. Top Bumper
C. Lower Bumper
A
C
B
Figure 25. Install Collector Mount Plate
A. Mount Plate
B. 3/8" Bolts & Washers (previously removed)
C. 3/8-16 x 1-1/2" Bolts & 3/8" Washers
D. Support Bar
E. 3/8-16 Nylock Flange Nuts
www.ferrismowers.com | www.snapperpro.com
B
A
D
E
E
Advertisement
Table of Contents
