Table of Contents
Advertisement
2
Mounting and
Powering
The MultiFlex boards are usually mounted by
the refrigeration equipment manufacturer.
Therefore, the installer need only make the
necessary connections between the boards and
the site controller(s).
In some instances, an installer may be required
to mount an I/O board. There are no restrictions
on the location of these boards; however, for
ease of network configuration, it is
recommended that the boards be located
adjacent to the Einstein. I/O boards may be
mounted without an enclosure, but they should
be mounted in a location that is not easily
accessible to avoid tampering or damage.
2 • MultiFlex RTU Operator's Guide
2.1. Snap-Track Installation
MultiFlex boards not supplied in a custom panel
or other enclosure are supplied with a snap-track
for easy installation. The insulation sheet and
I/O board must be removed from the track
before the track is mounted. The snap-track is
mounted using the 0.1875" mounting slots.
Figure 2-1 shows this installation procedure.
Figure 2-1 - MultiFlex Snap-Track Mounting
Figure 2-2 provides mounting dimensions for
the MultiFlex board.
Figure 2-2 - MultiFlex Board Dimensions
026-1706 Rev 3
Advertisement
Table of Contents
