Using A Cd/Dvd-Rom Drive - eMachines emonster Series User Manual

.........................................................................................................................................

Using a CD/DVD-ROM Drive

To insert a CD/DVD into the CD/DVD-ROM drive, first turn on your system. Then press the load/
eject button to open the disc tray. When the disc tray pops out, the busy indicator light will flash.
Put the CD/DVD in the tray with the label side up. Press the load/eject button again or gently push
the disc tray to close it.
When you want to remove the CD/DVD, make sure the busy indicator is off; then press the load/
eject button. When the tray pops out, remove the CD/DVD and then press the button again to close
the tray.
NOTES
When your system is turned off, you may need to open the tray. At this time, insert a fine rod such
as an opened paper clip into the emergency eject hole as far as it will go. When the tray is slightly
open, carefully pull it out.
You computer references the CD/DVD-ROM drive as D: unless you have more than one hard disk
drive or partition. Then it automatically recognizes it as the next available drive letter.
......................................................................................................................................................................................................................................
CD/DVD-ROM disc
3-3
Using Your Computer