Changing The Jumpers - eMachines emonster Series User Manual

Changing the Jumpers

The jumpers are small electrical connectors that control various circuits or functions in your
system.
Jumpers are small blocks on a circuit board with two or more pins emerging from them. To
change a jumper setting, pull the plug off its pins and carefully fit it down onto the pins indicated.
The jumpers settings in your computer are preset at the factory; however, you can alter the
functions by changing the standard settings:
Enable or disable the password function.
Clear the CMOS settings.
Enable or disable the FDD write protect.
Enable or disable the built-in audio function.
NOTE
The jumpers settings and their functions are inscribed on the label attached in your system
chassis. If you want to see the label, you need to remove the cover of your system.
CAUTION
Do not change the jumpers with the power on. Always turn off the computer and unplug the power
cord from the computer before changing the jumpers.
......................................................................................................................................................................................................................................
5-6
Inside Your Computer
.........................................................................................................................................