Replacing A Hard Disk Drive - eMachines emonster Series User Manual

.........................................................................................................................................

Replacing a Hard Disk Drive

Your hard disk drive is installed in the HDD bracket attached on the chassis. You can install one
hard disk drive in the HDD bracket.
Follow these steps to replace the hard disk drive:
1. Remove the system cover according to the instructions in "Removing the Cover" in Chapter 5.
2. Remove the screw securing the HDD bracket to the computer. And then slide the HDD bracket,
as shown below.
3. Detach all cables from the hard disk drive in the HDD bracket.
4. Remove the screws from the HDD bracket.
......................................................................................................................................................................................................................................
HDD bracket
Hard disk drive
Installing and Removing Board Options and Drives
6-7