Figure 5-4 Connecting Option Module Om 2.1 To Analyzer Modules 1 And 2 Using Example Of; Figure 5-5 Cabling Of Om2.1 With Am1 And Am2 - Siemens SIPROCESS GA700 Operating Instructions Manual

Connecting the option module OM 2.1
Connect the option module OM 2.1 to the analyzer module PCB
the existing 26-pin ribbon cable.
1
2
①
Figure 5-4
③
④
Figure 5-5
1. Install the housing cover.
Rack-mounted device
Operating Instructions, 01/2013, A5E31874006-01
Analyzer module printed circuit board
Connecting option module OM 2.1 to analyzer modules 1 and 2 using example of
OXYMAT 7
Processing unit
Option module OM 2.1
Cabling of OM2.1 with AM1 and AM2
Note
Tightening the cap nuts
Tighten the cap nuts with a torque of
• 2.5 Nm.
Installing the analyzer modules and option module
5.4 Installing the option module OM 2.1
②
Analog current interface, 26-pin ribbon cable to
option module
⑤
Plug contact AM2
⑥
Plug contact AM1 (AM in housing on
outside right)
①
of the OXYMAT 7 using
33